Big fire enjoyment in a small space: The small kit system storage heater KSO is a masonry heater with a small footprint. Dimensionally accurate moulded parts enable the quick, inexpensive construction of a compact storage heater that provides pleasant radiant heat for many hours. The slim column format with a round or square ground plan is available in a ceramic or concrete look, but can also be realised with a hand-made shell in a plastered surface.
Small storage stoves are installed when heat is primarily desired and it should be available for hours after the stove has burnt down. Small storage stoves are pure storage heaters. The energy of the heating gases is collected in the all-ceramic combustion chamber and when the heating gas passes the storage, it is released across the surface with a time delay. In terms of heating functioning, this is a real "slow-reaction furnace".
Small storage stoves take a long time to heat up, but they stay warm all the longer for it. If possible, they are fired daily during the entire heating season. This type of heating became known through ground stoves, the most original and oldest representative of all tiled stoves.
Manually operated or automated
With just one control (lever), the combustion air can be regulated manually. Effortless and easy to understand. The symbols on the viewing glass provide additional support.
Of course, it can also be operated automatically, as shown on the white display (EAS) . The most convenient version is the combination with an electronic combustion control (EAS). All you have to do is light the stove or add fuel, the control takes care of everything else. Highly efficient, because the EAS's servomotor never forgets to readjust and always stops the combustion air supply at the end of the burn-off. This is particularly convenient if the furnace cannot be operated any further after it has been lit, because you are going to bed or leaving the house.
Puristic, stylish and elegant - the fireplace body in its simplest form and appearance. Precisely fitting thermal concrete elements, poured and assembled with shadow gap. Here, perfection lies in the imperfect. The concrete surface has edges and irregularities, which is precisely why it looks so clear and unobtrusive. It is highly advisable to seal the thermal concrete elements with carnauba wax after assembly. This is absolutely recommended to avoid unwanted stains permanently. Because once a hand or shoulder with natural skin grease has leaned against the cold fireplace cover, the dark stain is almost impossible to get rid of. Other liquids are also absorbed by the concrete surface and permanently change its appearance.